" id="b1img" alt="米课”N+1“思维建站-非官方免费技术支持,Wordpress/Zencart/Opencart建站、SEO" title="米课”N+1“思维建站-非官方免费技术支持,Wordpress/Zencart/Opencart建站、SEO">
  • " alt="米课”N+1“思维建站-非官方免费技术支持,Wordpress/Zencart/Opencart建站、SEO" title="米课”N+1“思维建站-非官方免费技术支持,Wordpress/Zencart/Opencart建站、SEO" />
  • " alt="Windows/Linux服务器运维技术支持 环境搭建、应用发布、服务器管理、虚拟化、云计算" title="Windows/Linux服务器运维技术支持 环境搭建、应用发布、服务器管理、虚拟化、云计算" />
  • " alt="高校/小型企业网络运维与建设免费技术支持,网络规划、网络优化、故障排除、网络管理" title="高校/小型企业网络运维与建设免费技术支持,网络规划、网络优化、故障排除、网络管理" />

Large Networks: 5-4-3 Rule

网络运维2008-04-11 itlogger阅读(502) 评论(0)

A network is also limited in its maximum size, when Repeaters and/or hubs are used to extend a Thin Ethernet (10base2) or Twisted Pair Ethernet (10baseT/UTP) network, on large configurations, a Switch may become necessary to optimize network utilisation..

On Thin-Ethernet, the rules are:

– minimum 0.5 m between T-connectors
– maximum 185 m cable length
– maximum of 30 nodes (i.e. connections)

An cable can be extended by installing Repeaters, which amplify the signal:

A Repeater counts on each segment as a node and can be connected at ANY location in the Thin-Ethernet cable.
However, if a network needs more than 2 repeater:

the following limitations apply:
When an Ethernet signal travels from its source to destination station, it can travel through:
– maximum of 5 segments
– maximum of 4 Repeaters/hubs
– maximum of 3 populated segments
(Populated segments have more than 2 nodes connected, un-populated segments have only a node at each end, so a 10baseT-segments is a non-populated segment).

And for this discussion, a 10BaseT-Hub is like a repeater and a 10baseT cable can be treated as a cable 10base2-cable with just 2 systems on it.

There can be more repeaters/hubs in the complete network, and an Ethernet signal can pass-by more than 4 Repeaters/hubs, as long it does not have to go THROUGH more than 4 Repeaters/hubs.

If these rules are violated, the network becomes unreliable.

转载请注明 :IT樵客
文章地址:http://www.itlogger.com/network/471.html

发表评论

电子邮件地址不会被公开。 必填项已用*标注